Tanning rabbit fur12/19/2023 ![]() Clean them well (soap and water?) but go gently, they can break fairly easily. The tails generally have a lot of fat on them. Of course if the animal was struck by a car and has Good Year stamped in the facial fur, you may want to cut the mask off entirely. The membrane on the head or mask is the toughest to get off, so take your time. Just move on to the next area and keep scraping. This is usually from animals killed during the summer or early fall. Sometimes hair will pull back through the underside of the skin. Remove all the fat, meat and membrane until you begin to see the pores of the skin. I also use the same scraper used on buffalo.įleshing a pelt, tacked out on a plywood board Definitely not a good beginners project! You can use a fairly crescent shaped knife held at a 90 degree angle to the pelt. Buffaloes I stake out right on the ground. (Sorry, it’s an old butchers saying.) Now, throw it over a very smooth log or tack it out flat on a piece of plywood (see photo). To simplify your first project, slice the hide open all the way up the belly to the hair of the chinny-chin-chin. Also very warm as socks though usually the fur is short lived. They’re great for bags and pouches to flip over a belt. Pelts taken off in this manner are referred to as cased. Cut through the cartilage beneath the nose and ears. It will sometimes want to pull off with the pelt. Always leave as much of the fat and meat on the carcass as possible. However, if the carcass is cold, this stuff acts like rubber cement and must be cut carefully, particularly at the head, neck and tail. If the raccoon is a fairly fresh kill and still warm, the membrane and pelt will pull away easily. Only use your knife if absolutely necessary. Using the knife gently, begin pulling the pelt up away from the leg and cut the film or membrane that holds the skin to the meat.Īs much as possible pull the pelt off the carcass. Next cut the tail on the underside from the vent to it’s tip. ![]() With knife or sharp stone in hand make an incision from the hock to the vent (see diagram 1). To remove the pelt from the body or carcass, tie both back legs to a tree limb about head high. The process is an easy one and will start you on the way to using all of the animal when you take it’s life. ![]() But whether from the trap or the road, each animal comes with a complete tanning package - no chemicals are needed. It was a large, fluffy road kill raccoon I named Ricky. ![]() My hat is made from the first pelt I ever tanned. Nonetheless, a pair of rubber gloves are recommended when handling these critters from the wild. Many of these pelts are in perfect condition. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |